Your computer’s original hard drive may also contain a “Recovery” partition but this will no longer be needed as your image backup or subsequent backups will serve as a means of For instance when using Ghost or Acronis, one option to remember when restoring the image file to the new drive is not to choose to restore the Master Boot Record (MBR).3) IDE drives are simpler: They always use Molex connectors. The old drive is your ultimate fall safe/backup should anything go wrong with the new drive. Baseline configuration:Windows XP Professional with Service Pack 3250GB this contact form
If you already have a SATA drive installed, follow its power cable (the wider of the two connectors) to see if an unused power-supply lead with the same connector is nearby. See How To Partition a Hard Drive in Windows and then return here to continue.Note: Formatting the C drive, or whatever letter happens to identify the drive that Windows is installed If you can not find this option, a BIOS upgrade may solve your issue Important: If you want to install XP in dual boot with Vista, disabling the SATA controller can Navigate the BIOS and look for the option to disable SATA.
Step 5: Partition and format your hard drive Access Windows XP's Disk Management function from the Administrative Tools window in Control Panel. Please try again. Installing Windows Two scenarios are possible: You have a floppy drive After setting the BIOS to boot on the CD-ROM or DVD-ROM, insert the Windows installation CD and follow the steps Also, install Service Pack 2 or higher for Windows XP or Service Pack 4 or later for Windows 2000 in order to enable large drive support for your operating system.
That's not true of IDE, where a jumper indicates whether a drive is a primary ("master") or secondary ("slave") drive. Click Next yet again (to the Format Partition screen), and ensure that "Format this partition with the following settings" is selected and that the "File system" drop-down reads "NTFS." Click Next Tip: Using a SATA PCI interface card? How To Format A New Hard Drive Tip: An older PC might "see" just 137GB or less of your new drive, if it's 150GB or larger, due to limitations of its BIOS or OS version.
Windows XP must also have service pack 1A or later installed.Where to store the Image Backup:If you have an external USB hard drive capable of storing the image backup of Windows How To Install A New Hard Drive Windows 7 Click Start > Control Panel > Administrative Tools > Computer Management, and choose Disk Management from the tree at left. Then check whether a CD comes with the drive, providing drive-specific information and general upgrade assistance. Notes:1) Most laptops only allow for a single hard drive, therefore an external USB drive is required.2) EASEUS Todo backup is a free Image Backup solution, if you already have Ghost
For most users, leaving it as MBR will be sufficient. What Is Hard Drive Configuration Note that some older PCs use 40-conductor IDE cables, not the 80-conductor ones current drives require. (Compare your kit cable to the one installedâ€”the 80-conductor variety has much thinner wires.) 80-conductor In addition to the seven core levels (RAID 0 through RAID 6), you'll encounter a number of variants and combinations. Once partitioned, return to this page for help formatting the drive.Time Required: The time it takes to format a hard drive in Windows depends almost entirely on the drive's size, but
There are very few reasons to change this.Â In Windows 10, 8, and 7, the Perform a quick format option is checked by default but I recommend unchecking the box so a If you do not have a Windows CD and have an OEM computer, such as an Acer, Hewlett Packard, or Dell, the Windows install is done through a hidden partition. Install New Hard Drive Windows 10 Other options may include FAT32 or exFAT depending on your version of Windows. New Hard Drive Laptop It offers no boost in performance or redundancy and is a holdover from the days when smaller disks had to be chained to handle large amounts of data.
Some SATA drives also support familiar legacy Molex four-pin power connectorsâ€”you can use a Molex or SATA connector. http://comvurgent.com/hard-drive/windows-won-39-t-boot-with-second-hard-drive.html Otherwise, back up your important data. With XP and 2000, though, use Windows' Disk Management utility. Disk Management The Windows Disk Management should resemble what is shown in the above picture and display all drives detected by Windows, including any disks that have not yet been set Hard Drive Configuration Definition
This works by either striping data across a pair of drives then mirroring (0+1) them with another pair, or striping data across two mirrored pairs (1+0, aka 10). Should that drive fail you not only lose Windows but also the image backup on the drive, leaving you will no means of recovery. Here's How to Force it to Quit Read Article List Tutorials on Installing Windows 10, 8, 7, Vista and XP Read List Article How To Scan a Hard Drive Using 'Error navigate here If possible, buy a card that supports greater-than-2.2TB disks and 6Gbps SATA III.Two or more hard drives: If you decide on Windows software RAID, you may use any drives you choose.
See How to Change Drive Letters in WindowsÂ to see how.You can also format a hard drive via Command Prompt using the format command. What To Do After Installing A New Hard Drive If you're running a new version of Windows with a computer that supports GPT, you'll be prompted for the Partition Style. Instead of using an entire hard drive as a backup, RAID 5 spreads redundancy information--called parity bits--across all of the array's drives.
See How To Partition a Hard Drive in Windows for instructions. To set up a new hard drive and partitions in Windows, you must have administrative rights or be part of the backup operators group and follow the steps below. See if an unused SATA port lies nearby on the motherboard or an interface card. How To Set Up A New Hard Drive This document, titled "Installing Windows XP on a SATA hard drive," is available under the Creative Commons license.
See partition configuration #2A, 2B or 3B.Laptop users should look at 2.5 replacement drives such as the Western Digital Scorpio.Note: Computer purchased before 2005 with hard drives that are 120GB or See my Format Command: Examples, Switches, & More for details on how to do that. Important: If the hard drive you want to format has never been used, or was just wiped clean, it must first be partitioned. his comment is here The remaining drive space is used to create an ‘Extended’ partition with two ‘Logical’ drives as show below.4) It is not recommended that you use the same hard drive to store
Bays for internal drives are usually located below the wider, front-accessible bays that house CD or DVD drives. Click Next, and check that Primary Partition is selected; click Next again, to the Specify Partition Size screen (don't change the partition size in the "Partition size in MB" field); and SATA drivers can also be installed as third party drivers; you will be prompted during the installation process. They need not be the same size if you're mirroring individual volumes, though it's generally a good idea.Back in the days of parallel ATA, it was a no-no to mix drives
Check its documentation for the proper setting. The browser version you are using is not recommended for this site.Please consider upgrading to the latest version of your browser by clicking one of the following links. Windows RAID offers several advantages. You need at least two drives for RAID 0 and 1, three drives for RAID 5, and four for RAID 0+1, 1+0, and 10.Floppy drive (Windows XP-only): If you plan to
Test that new hard drive:A new drive does not automatically guarantee the drive is free of defects. hard drive (not uncommon for a 2004 to 2006 mid range desktop computer, some desktops or laptops may have only been outfitted with drives 160GB or less).Image Backup Software:EASEUS Todo Backup Right-click on the Disk you want to set up or change. YesNo Feedback E-mail Share Print Search Recently added pages View all recent updates Useful links About Computer Hope Site Map Forum Contact Us How to Help Top 10 pages Follow us
For Dual Boot configurations see Partition Configurations 1A, 1B, 2A or 2B -----> For just moving Windows XP to a larger hard drive see Partition Configurations 3A or 3B -----> --- Most hard drive kits include a data cable (SATA or IDE, depending on the drive), a power adapter cable (with some SATA drives), and screws.